- Wire Range
- Service & Capability
- Application Solutions
- Customer tools & resources
- Contacting Us
We’re exhibiting: Valve World Expo, Düsseldorf, Germany. 29th November – 1st December. Hall 1 Booth #C17. Learn more.
The method of manufacture. The cross sectional area of the round rod is reduced while the material is still hot. The surface finish is typically not as smooth as that for cold drawn wire and the diameter usually has a higher ovality than that for cold drawn wire.
The method of manufacture. The cross sectional area of the wire or thickness of the section is reduced without the use of heat.
Round wire rolled on 2 surfaces to leave naturally radiused edges.
Rolled round wire on 4 or more surfaces to control edges and radiused corners.
Specific amount of cold work to give standard spring temper condition for a grade of material.
Specific amount of cold work to give standard No 1 temper condition of the wire, but less cold work than that for full spring temper (not standard condition for all alloys).
Manufactured to customer’s specified mechanical properties.
Wire coated with dry lubricant to aid auto coiling (e.g. spring coiling).
No coating on wire surface.
Softened with heat treatment.
A condition achieved with heat treatment to increase the mechanical properties of the material (ie. Tensile strength / hardness etc). This process is typically carried out on the finished parts as forming aged wire may not be possible.
Standard heat treatments of finished parts are given and resulting mechanical properties are typical values. In most cases, different mechanical properties are achievable through a combination of cold work and heat treatment, please contact us to discuss your specific requirements.
We can carry out capability tests on samples to demonstrate our products ability to meet your requirements after final heat treatment and certify the results.
The tensile strength ranges given are typical ranges for each alloy for the specified standard condition of supply. Please be aware that as we manufacture these materials, tensile range can be altered to suit customer requirements.
The operating temperatures stated on our data sheets are approximate values which depend on the design and operating conditions of the finished component / part.
This is the date that the material will leave Alloy Wire, not the date of arrival at the customer’s dock.
If you require different mechanical properties to those stated, please contact us.